Seat Alhambra Key Problems

Seat's jumbo MPV family is among the top models in its class when it comes down to resale value. With a brand new model on sale, the family MPV jumbo is more impressive.

There are a myriad of reasons that the key fob might not work properly, such as a dead coin battery damage to the receiver module, water issues, or seat Alhambra key signal interference. This article will walk you through the steps necessary to make sure it works.

Water Damage

If your seat ibiza key fob alhambra key fob is able to withstand the wash cycle or a bath in the ocean or pool then it's probably equipped with an incredible waterproof chip, but be careful not to make this a routine as exposure to excessive water increases the chance of the key fob becoming damaged. If your key fob ceases to functioning after being exposed to rain or clean tap water, take out the battery and wipe the electronic component using a paper towel. Let it dry completely before replacing the battery. If the key fob has been exposed to salty or soapy water and salty water, it is recommended you clean the chip using isopropyl or electronic cleaner.

Faulty Receiver Module

If the key fob does not lock or unlock after you've replaced the battery in the button cell it is possible that the receiver module has a fault. The good news is that this is a relatively simple repair that is inexpensive, you can just remove the battery 12 volts for about a couple of minutes (first remove the negative cable and press the horn button numerous times) to remove any remaining electricity, and then connect it in reverse order e.g. Positive first and then negative.

ESP Warning Light - If the ESP warning light flashes, this is normal and signifies that the car is driving over terrain where the traction of the road surface and tyres aren't as good, such as gravel, snow or a lot of surface water. If the ESP warning light is constantly flashing, it means there is a problem within the system. This can be diagnosed using a iCarsoft i908 seat leon key fob replacement OBD Code Reader kit that will provide a precise fault description.

Dead Coin Battery

A dead coin battery is among the most common reasons for the seat alhambra keys to cease to function. The key fob contains an insignificant button cell battery that keeps it running. Replace it with a new battery that has the exact dimensions, voltage and specs as the original. When replacing the battery on the key fob remove all metal clips and ensure that the contacts on the key fob are clean and free of corrosion.

If the key fob was exposed to water (such as soapy tap water) it is recommended to remove and clean the chip using an electronic cleaner or isopropyl alcohol prior to installing a new battery. The chip is sensitive to moisture and can be permanently damaged. If the key fob still doesn't function after replacing the battery it might be necessary to replace the key fob.

Faulty Receiver Module

If your key fob has stopped working after you replaced the battery, but it did not help, or it just stopped working without notice, then your receiver module may have developed an issue. The receiver module is responsible for receiving the radio frequency signals that are sent by your remote key fob, and converting them into electrical commands that are then used by other modules within the car.

If the receiver module has a problem it will not take any commands from your remote key fob. In this case it is necessary for a dealer to reprogram your key fob, and also install an entirely new receiver.

The key fob comes with rubber seals to prevent water from getting into the electronic chip inside. If you dip the key fob into salted or soapy water it could damage the chip. You can try to clean the chip by applying isopropyl alcohol or electronic cleaner, but should your key fob does not work after this, then you'll need to buy a new one.

If the keys have been linked, but the receiver module isn't working, you can try to restart all the electronics in the board by disconnecting the battery that is 12 volts for a few minutes. Then reconnect the battery in reverse order (negative cable first, then positive). This will reset the onboard electronic and restore their functionality.

Faulty Electronic Chip

The key fob has an electronic chip which transmits a signal the receiver module each time the key is used. If the signal isn't in line with the one that the car has stored the immobilizer will turn off and stop the car from starting. If the key fob is not working and you cannot reprogram it, it could be due to a defective chip.

The chip inside the key fob is not a permanent part of the device and may need to be replaced in order to get it working again. The best method to do this is to remove the key from its housing and then using a pin or needle to get into contact with each of the metal retaining clips. You'll need to replace these in the event of damage or corroded. Make sure that the replacement batteries are the same voltage, size and specification as the original.

The Seat Alhambra is an attractive and well-designed model but, as with any car it may encounter problems with specific components or equipment. A few owners have reported issues with the auto climate control system. It is prone to fail and cause problems, and then get stuck in a particular setting. Additionally, the infotainment feature has also been found to malfunction and cause freeze screens.