Subaru Impreza Key Problems

Subaru Impreza keys enable owners to lock and unlock their vehicles with just a push of the button. A dead battery for the coin in the key fob is the most common reason for the key fob to cease to function.

It is easy to replace the battery. Find the small battery that is the round flat cell within the key casing. Open it and replace the battery, making sure that the right side is facing upwards.

Lost or Stolen Keys

We've all been there where you reach into your purse to grab your keys, but they're not to be found. It's not hard to find your Subaru keys and there are many ways to change them quickly and cost-effectively.

If you own a standard metal key you can take it to a store or locksmith that sells Subaru blanks (these are typically marked with "Subaru") and get them duplicated. If they want to replace batteries in the key fob, they can purchase a CR-2032 from many hardware stores or online retailers such as Amazon.

You'll have to visit a Subaru dealer or automotive locksmith to program new keys. This will cost you between $50-$250 depending on whether your Subaru features a transponder chip or smart key feature.

You'll have to provide the locksmith or dealer with your vehicle identification number (VIN) found on the dashboard, close to the windshield. They'll require this number to verify that your car is covered by warranty and that the new key is correctly encoded for the specific model and year of your subaru new key fob cost. The VIN provides details about the manufacturer and the location where the vehicle was made. It also tells you what special features on the vehicle like immobilizers, which hinder the engine from starting in the event of a misplaced key being used.

Faulty Key Fob

A key fob that does not function properly could be caused by a number of reasons. It could be due to a simple issue with the battery or it may need a more complex fix. A dead battery, programming problems with the car, or any other electrical issues with the vehicle are some of the most common problems with the Subaru keyfob.

One of the simplest fixes is to replace the battery on the key fob. These are available at a few big-box stores and hardware stores. They cost around $10 each and can be replaced in a few minutes. how to reprogram a subaru key fob to do this is in the owner's guide. There are many YouTube videos that will walk you through the process.

Damage from water to the key fob is another possible cause. Taking it out of the pocket and getting it wet can damage the clips made of metal that hold the battery in place. If the key fob still has issues after replacing the batteries, the problem may be related to the transmitter or other components of the vehicle. A trained technician can check these parts and troubleshoot the vehicle to identify the problem. They can reprogramme your key fob in order to ensure it is compatible with your vehicle. They can also examine for any wiring or antenna issues which could stop the keyfob from transmitting data correctly.

Locking or Unlocking Issues

If your Subaru Impreza key fob won't unlock or lock the doors, it could be a range of causes. A dead battery in the key fob or a malfunctioning receiver or water damage, signal interference or a key that requires reprogramming are all possible causes of this problem. To fix this, you can go to a locksmith or a dealer to have the key fob reset.

If you're unable to access the trunk the key fob might have the setting for the trunk lock set to "on". This is a security measure that stops thieves from taking the car. You can alter the setting for the trunk lock/unlock by making contact with your subaru outback key replacement dealer.

A locked steering column can also occur when the vehicle locks automatically following a sharp turn. This happens when the car senses a rapid turn, which could affect the transmission system and engine. Be careful when turning to avoid this.

Verify that the dealer locksmith has programmed and cut the spare keys or replacement key fob subaru keys you have. Also, ensure that the emergency key works on each of the trunks and doors, as these are the only means to access the vehicle when locked out. Check that the spare key or the new key doesn't have any scratches or signs on it.

Keyless Entry

Many Subaru models are equipped with keyless entry that allows you to lock and unlock the doors and trunk with the press of a button your remote. The system utilizes a radio signal to connect with the vehicle when you are within the range. There are many different systems that offer this functionality. They range from simple kits which unlock only the door of the driver, to more sophisticated ones that permit remote starting and connectivity to smartphones.

It's convenient and safe to have keyless entry into your Subaru however, you need to know what to do in the event that the buttons stop functioning. You can do some troubleshooting at home, but you may need to take your Subaru to a specialist for a diagnosis. In the meantime, use these tips to keep your car's remote working as it should.

If your Subaru's key fob becomes wet, it's a good idea to clean the electronic chip of it by using isopropyl ethanol and let it dry completely before putting the battery back into. This will prevent moisture from damaging your fob or causing issues later on.

If your key fob has stopped responding, shut off the engine and then open the door to the driver. Press the door button once to open it, and the second time to close it. You'll need to press the button a handful of times in a row, usually one for each digit until you hear the sound. Repeat the procedure for each door until all doors respond.